长江科学院院报 ›› 2016, Vol. 33 ›› Issue (10): 79-83.DOI: 10.11988/ckyyb.20160355

• 岩土工程 • 上一篇    下一篇

砂雨法制备三轴砂样的影响因素及均匀性研究

程朋1,2,王勇2,李雄威3,孔令伟2,王艳丽4   

  1. 1.安徽理工大学 土木建筑学院,安徽 淮南 232001;
    2.中国科学院武汉岩土力学研究所 岩土力学与工程国家重点实验室,武汉 430071;
    3.常州工学院 土木建筑工程学院,江苏 常州 213002;
    4.长江科学院 水利部岩土力学与工程重点实验室,武汉 430010
  • 收稿日期:2016-04-18 出版日期:2016-10-20 发布日期:2016-10-17
  • 通讯作者: 王 勇(1977-),男,河南周口人,副研究员,博士,主要从事特殊土力学与灾害防治研究,(电话)13517246178(电子信箱)wang831yong@163.com。
  • 作者简介:程 朋(1992-),男,江苏沛县人,硕士研究生,主要研究方向为海洋含气沉积物的声学特性,(电话)18761723710(电子信箱)cheng95peng@163.com。
  • 基金资助:
    国家自然科学基金项目(51579237, 51309027);江苏省自然科学基金项目(BK20131141);深部岩土力学与地下工程国家重点实验室基金项目(SKLGDUEK1110)

Factors and Homogeneity of Triaxial Sand Specimens Preparation with Air Pluviation

CHENG Peng1,2, WANG Yong2, LI Xiong-wei3, KONG Ling-wei2, WANG Yan-li4   

  1. 1.School of Civil Engineering and Architecture,Anhui University of Science and Technology,Huainan 232001,China;
    2.State Key Laboratory of Geomechanics and Geotechnical Engineering,Institute of Rock and SoilMechanics, Chinese Academy of Sciences, Wuhan 430071, China;
    3.School of Civil Engineering &
    Architecture, Changzhou Institute of Technology,Changzhou 213002, China;
    4. Key Laboratory of GeotechnicalMechanics and Engineering of the Ministry of Water Resources, Yangtze River Scientific Research Institute,Wuhan 430010, China
  • Received:2016-04-18 Online:2016-10-20 Published:2016-10-17

摘要: 为了得到较为真实的室内重塑砂土样,利用自制的落砂装置,开展一系列福建标准砂的砂雨法制样试验,研究落距、漏斗管径和细颗粒含量等因素对室内土工三轴试验砂样制备的影响。结果表明砂样相对密度随落距的增加而增加,而增速随落距的增加逐渐变缓并趋于稳定;相同落距下,漏斗管径越大,砂样的相对密度越小;漏斗管径的减小,可以得到较宽范围的砂样密度;随着砂土中细颗粒含量的增加,制备的砂样相对密度减小。利用牛顿第二定律和能量守恒定律能够较好地阐释落距、漏斗管径和细颗粒含量等因素对砂土制样的影响规律。采用225kV-3D微分辨率ICT对砂雨法制备的砂样进行细观扫描,并借助ImageJ软件,重构砂样三维模型,计算出沿砂样高度方向的每层孔隙占比,验证了砂雨法制备砂样的空间均匀性,并给出砂雨法制备室内三轴试样的合理化建议。

关键词: 砂雨法, 砂样制备, 砂土, CT扫描, 均匀性

Abstract: The influences of drop height, funnel diameter and fine particles’ contents on sand specimen preparation for indoor geotechnical triaxial test were studied through preparation test of Fujian standard sand with self-manufactured air pluviation device. Results showed that the relative density of sand specimens increased with the increasing of drop height, and the growth rate slowed down and tended to be stable. The relative density of sand specimens decreased along with the increase of funnel diameter under the same drop height. A wider range of relative density can be achieved with the decrease of funnel diameter. The relative density of sand specimens decreased with the increasing of fine particles’ contents. The influences of drop height, funnel diameter and fine particles’ contents on the relative density of sand specimens can be well explained by Newton’s second law and conservation of energy. The gray image scanned with the 225 kV micro-computerized tomography of sand specimens prepared by air pluviation was analyzed by ImageJ software. The spatial homogeneity of sand specimens can be verified by reconstructing the three-dimensional model of sand specimens and calculating the proportion of sand pore area along the height of sand specimen. Furthermore, reasonable suggestions on preparing triaxial sand specimens were proposed.

Key words: air pluviation, sand preparation, sand, CT scanning, homogeneity

中图分类号: