长江科学院院报 ›› 2013, Vol. 30 ›› Issue (5): 86-91.DOI: 10.3969/j.issn.1001-5485.2013.05.019

• 水工结构与材料 • 上一篇    下一篇

南水北调中线工程?河渡槽三维有限元分析

郑重阳,彭辉,任德记   

  1. 三峡大学水利与环境学院,湖北宜昌 44300
  • 收稿日期:2012-04-06 修回日期:2013-04-28 出版日期:2013-04-28 发布日期:2013-04-28
  • 通讯作者: 彭 辉(1976-),男,湖北武汉人,副教授,博士,主要从事水工结构和工程力学研究,(电话)0717 -6392878(电子信箱)hpeng1976@163.com。
  • 作者简介:郑重阳(1985-),男,河南商丘人,硕士研究生,从事水工结构工程研究,(电话)15997699367(电子信箱)zcy946@163.com。

Three-Dimensional FEM Analysis on Jihe River Aqueduct in the Middle Route of South-to-North Water Diversion Project

ZHENG Chong-yang,PENG Hui,REN De-ji   

  1. College of Hydraulic and Environmental Engineering, Three Gorges University, Yichang 443002, China
  • Received:2012-04-06 Revised:2013-04-28 Online:2013-04-28 Published:2013-04-28

摘要: 南水北调大型渡槽流量大、跨度大等特点,对渡槽的设计提出了更高的要求。结合南水北调?河渡槽的工程实例,运用三维有限单元法对该渡槽的受力性能进行模拟,同时重点考虑预应力和温度荷载的影响,研究了渡槽槽身各部位控制断面的应力、变形分布规律。计算结果表明:槽身截面设计和预应力筋布置方案合理,应力和位移均在允许范围内,满足抗裂和挠度要求。

关键词: 南水北调 , 大型渡槽 , 预应力配筋 , 有限元法 , 热-应力耦合

Abstract: Large flow and long span of the large-scale aqueduct in South-to-North Water Diversion Project pose higher requirements for the aqueduct design. Taking the Jihe River Aqueduct for example,the structural behavior of the aqueduct was simulated by using 3-D FEM method. In consideration of pre-stress and temperature load,the distribution of stress and deformation in different control sections of the aqueduct body was analyzed. Result indicates that the design of the aqueduct body section and the scheme of pre-stressed reinforcement are reasonable. Stress and displacement are within the allowable range and both meet the requirements of anti-crack and deflection.

Key words: south-to-north water diversion project , large aqueduct , pre-stress reinforcement , FEM method , thermal stress coupling

中图分类号: