长江科学院院报 ›› 2020, Vol. 37 ›› Issue (12): 81-85.DOI: 10.11988/ckyyb.20190988

• 岩土工程 • 上一篇    下一篇

考虑温度效应的冻结黏土内变量蠕变模型分析

姚兆明, 张雯, 郭梦圆   

  1. 安徽理工大学 土木建筑学院,安徽 淮南 232001
  • 收稿日期:2019-08-14 修回日期:2019-10-25 出版日期:2020-12-01 发布日期:2020-12-28
  • 作者简介:姚兆明(1975-),男,安徽黄山人,教授,博士(后),主要从事岩土体本构模型及数值分析研究。E-mail:zhmvaoaust@126.com
  • 基金资助:
    地下工程福建省高校重点实验室开放课题基金项目(KF-T18014);安徽理工大学研究生创新基金项目(2019CX2021); 陕西省煤田地质集团有限公司科研项目(SMDZ-2019CX-7)

An Internal-variable Creep Model for Frozen Clay in Consideration of Temperature Effect

YAO Zhao-ming, ZHANG Wen, GUO Meng-yuan   

  1. School of Civil Engineering and Architecture, Anhui University of Science and Technology,Huainan 232001, China
  • Received:2019-08-14 Revised:2019-10-25 Online:2020-12-01 Published:2020-12-28

摘要: 在冻结法施工中掌握冻土的蠕变特性对工程的安全评价至关重要。采用山西某矿井深部黏土,在负温条件下进行原状土单轴压缩试验与分级加载蠕变试验,研究冻结黏土破坏时的形态、一系列温度下的单轴抗压强度与蠕变曲线的形式。试验得出单轴抗压强度随温度降低呈线性变化,同一加载应力下的蠕变值随着温度的降低而减小。引入内变量理论并将应变作为内变量来描述冻土的蠕变特性,分析蠕变与蠕变率取对数的拟合曲线发现两者具有线性关系,进而建立只与温度和加载系数有关的内变量蠕变模型,模型参数可通过拟合曲线确定。将蠕变的计算值与试验结果对比,发现该模型可以较好地反映冻结黏土的蠕变,且模型参数少,便于工程应用。

关键词: 冻结黏土, 单轴抗压强度, 蠕变试验, 内变量, 温度效应, 蠕变模型

Abstract: Safety evaluation of artificial freezing method depends on the creep characteristics of frozen soil. Uniaxial compression test and staged loading creep test were conducted at temperatures below 0 ℃ on undisturbed clay collected from a deep mine in Shanxi Province to study the failure mode and mechanism of the frozen soil as well as the form of uniaxial compressive strength and creep curves at different temperatures. The uniaxial compressive strength varied linearly with the declining of temperature, and the creep value under the same loading stress also decreased with the drop of temperature. In line with the internal variable theory, strain was considered as the internal state variable to describe the creep characteristics of frozen soil. The fitting curve of logarithm of creep and creep rate suggested a linear relationship between them. On such basis, an internal variable creep model that was only related to temperature and loading coefficient was established. Parameters of the model could be determined by fitting curves. The fitting of test data into the model showed that the model could better reflect the creep of frozen clay with less model parameters, and is convenient for engineering application.

Key words: frozen clay, uniaxial compressive strength, creep test, internal variable, temperature effect, creep model

中图分类号: