长江科学院院报 ›› 2020, Vol. 37 ›› Issue (6): 108-114.DOI: 10.11988/ckyyb.20190099

• 岩土工程 • 上一篇    下一篇

非线性条件下加筋土边坡上限法的研究

张玮鹏1,2, 李冬冬2, 曾光辉2, 张石虎2, 崔梦轩3   

  1. 1.长江勘测规划设计研究有限责任公司,武汉 430010;
    2.长江岩土工程总公司(武汉),武汉 430010;
    3.中国市政工程 中南设计研究总院有限公司,武汉 430010
  • 收稿日期:2019-01-24 出版日期:2020-06-01 发布日期:2020-06-21
  • 作者简介:张玮鹏(1992-),男,黑龙江大庆人,工程师,硕士,主要从事边坡稳定性分析方面的研究。E-mail:zhangweipeng@qq.com
  • 基金资助:
    国家重点研发计划项目(2018YFC1505006)

Upper Bound Method for Reinforced Soil Slopes under Nonlinear Mohr-Coulomb Yield Condition

ZHANG Wei-peng1,2, LI Dong-dong2, ZENG Guang-hui2, ZHANG Shi-hu2, CUI Meng-xuan3   

  1. 1. Changjiang Institute of Survey, Planning, Design and Research, Co. , Ltd. , Wuhan 430010, China;
    2. Changjiang Geotechnical Engineering Corporation (Wuhan), Wuhan 430010, China;
    3. Central and Southern China Municipal Engineering Design & Research Institute Co. , Ltd. , Wuhan 430010, China
  • Received:2019-01-24 Online:2020-06-01 Published:2020-06-21

摘要: 大量的工程实践证明,岩土材料的屈服条件呈现非线性,且越是高地应力地区这种趋势越明显,但目前基于非线性的加筋土边坡稳定性分析的研究还较少。采用非线性摩尔-库伦屈服条件,以极限分析上限法为基础,研究边坡稳定性问题。引入新的强度参数ctφt,以对数螺旋线为破裂面对非加筋土和加筋土进行研究,推导了非加筋土坡稳定性系数Ns、安全系数F、非加筋土极限坡高H1和加筋土坡极限坡高H2的计算公式。在算例中采用MatLab程序进行计算,得出了较好的结果。总结了非线性参数m对抗剪强度指标参数ctφt的影响,即随着m值的增加,φt值逐渐减小,而ct的值则先增大后减小;同时也得出了当其他条件不变时坡角β越大,边坡的极限坡高H越小的结果。

关键词: 加筋土, 边坡稳定性, 极限分析上限法, 非线性破坏准则, 数学规划法, 塑性理论

Abstract: A large number of engineering practices have proved that the yield conditions of geotechnical materials are nonlinear. Such nonlinearity is more evident in areas of high geostress. However, at present, nonlinear studies on the stability of reinforced soil slope are inadequate. In this paper we research the slope stability under nonlinear Mohr-Coulomb yield condition via upper bound limit analysis. By introducing new strength parameters ct and φt, we obtain the calculation formulae of stability coefficient Ns of non-reinforced soil, safety coefficient F, ultimate height H1 of non-reinforced soil, and ultimate height H2 of reinforced soil slope with logarithmic helix as fracture surface. Good results are obtained in a computation example using MatLab. Moreover, the influences of nonlinear parameter m on shear strength index parameters ct and φt are summarized. With the increase of m, φt decreases gradually while ct increases at first and then decreases. In addition, the limit slope height H reduces when slope angle β increases with other conditions unchanged.

Key words: reinforced soil, slope stability, upper bound limit analysis method, nonlinear failure criterion, mathematical programming method, theory of plasticity

中图分类号: