Particle Flow Simulation of Direct Shear Test on Rock Mass Containing Discontinuous Joints with Different Roughness Coefficients

ZHANG Zhi-fei; TANG Wei-min; JIA Hong-biao

doi:10.11988/ckyyb.20191101

PDF(4920 KB)

Journal of Changjiang River Scientific Research Institute ›› 2020, Vol. 37 ›› Issue (12) : 126-132. DOI: 10.11988/ckyyb.20191101

ROCKSOIL ENGINEERING

Particle Flow Simulation of Direct Shear Test on Rock Mass Containing Discontinuous Joints with Different Roughness Coefficients

ZHANG Zhi-fei¹, TANG Wei-min², JIA Hong-biao¹

Author information +

History +

Abstract

The crack propagation process and failure mode of discontinuous jointed rock mass with different roughness coefficients under different normal stresses are studied via particle flow method, and the stress evolution process of pre-shearing plane is discussed. Results reveal that the failure modes of rock bridge can be roughly divided into five categories according to the tensile and shear properties of micro-cracks and their evolution process, which are closely related to the normal stress and joint surface roughness coefficients. The increments in normal stress and joint surface roughness coefficients would instigate rock bridge towards shear failure. The angle between the initial wing crack and the original joint surface is not sensitive to the change of normal stress; but declines with the increase of joint roughness coefficients. In the shearing process, the stress on the pre-shearing plane does not distribute uniformly and meanwhile redistributes continuously. The shear stress of flat jointed rock mass is mainly borne by rock bridge, and the compressive stress of the rock bridge is greater than that of the joint in both horizontal and normal directions, while for rough jointed rock mass, the shear stress is borne by both the joint and the rock bridge, and the stress of the joint part is higher than that of the rock bridge.

Key words

discontinuous jointed rock mass / joint roughness coefficient / fractal model / rock bridge / failure mode

Cite this article

EndNote

Ris (Procite)

Bibtex

Download Citations

ZHANG Zhi-fei, TANG Wei-min, JIA Hong-biao. Particle Flow Simulation of Direct Shear Test on Rock Mass Containing Discontinuous Joints with Different Roughness Coefficients[J]. Journal of Changjiang River Scientific Research Institute. 2020, 37(12): 126-132 https://doi.org/10.11988/ckyyb.20191101

References

[1] LAJTAI E Z.Shear Strength of Weakness Planes in Rock[J]. International Journal of Rock Mechanics and Mining Science & Geomechanics Abstracts, 1969, 6(5): 499-515.
[2] LAJTAI E Z. Strength of Discontinuous Rocks in Direct Shear[J]. Geotechnique, 1969, 19(2): 218-233.
[3] 朱维申, 李术才, 陈卫忠. 节理岩体破坏机理和锚固效应及工程应用[M]. 北京:科学出版社, 2002.
[4] WONG R H C, CHAU K T, TSOI P M, et al. Pattern of Coalescence of Rock Bridge between Two Joints under Shear Loading[C]//International Congress on Rock Mechanics. Rotterdam: A. A. Balkema, 1999: 735-738.
[5] 刘远明, 夏才初. 直剪条件下非贯通节理岩体岩桥力学性质弱化机制及贯通模型初步研究[J]. 岩土力学, 2010, 31(3): 695-701.
[6] 陈国庆, 王剑超, 王伟, 等. 不同连通率断续节理岩体直剪破坏特征[J]. 工程地质学报, 2017, 25(2): 322-329.
[7] 张黎明, 陈国庆, 李志波, 等. 共面断续岩桥直剪试验破坏过程研究[J]. 长江科学院院报, 2018, 35(10): 124-129,146.
[8] 唐志成, 夏才初, 丁增志. 非贯通类节理岩体剪切变形规律分析[J]. 岩土力学, 2011, 32(8): 2353-2358.
[9] 刘远明, 刘杰, 夏才初. 不同节理表面形貌下非贯通节理岩体强度特性直剪试验研究[J].岩土力学, 2014, 35(5): 1269-1274.
[10]刘顺桂, 刘海宁, 王思敬, 等. 断续节理直剪试验与PFC2D数值模拟分析[J]. 岩石力学与工程学报, 2008, 27(9): 1828-1828.
[11]蒋明镜 ,孙亚 ,陈贺, 等. 非贯通非共面节理岩体直剪试验DEM数值模拟[J]. 岩石力学与工程学报, 2015, 34(增刊2): 3667-3675.
[12]蒋明镜, 刘蔚, 孙亚, 等.考虑环境劣化非贯通节理岩体的直剪试验离散元模拟[J]. 岩土力学, 2017, 38(9): 2728-2736.
[13]ZHANG X P, WONG L N Y. Cracking Processes in Rock-Like Material Containing a Single Flaw Under Uniaxial Compression: A Numerical Study Based on Parallel Bonded-Particle Model Approach[J]. Rock Mechanics and Rock Engineering, 2012, 45(5):711-737.
[14]ZHANG X P, WONG L N Y. Crack Initiation, Propagation and Coalescence in Rock-like Material Containing Two Flaws: A Numerical Study Based on Bonded-particle Model Approach[J]. Rock Mechanics & Rock Engineering, 2013, 46(5):1001-1021.
[15]POTYONDY D O. A Flat-jointed Bonded-particle Material for Hard Rock[C]//American Rock Mechanics Association. Proceedings of the 46th US Rock Mechanics/Geomechanics Symposium. Chicago, IL, USA, June 24-27, 2012: 1510-1519.
[16]余华中, 阮怀宁, 褚卫江.大理岩脆-延-塑转换特性的细观模拟研究[J]. 岩石力学与工程学报, 2013, 32(1): 55-64.
[17]XIE H P,PARISEAU W G.Fractal Estimation of Joint Roughness Coefficients[J]. International Journal of Rock Mechanics & Mining Sciences & Geomechanics Abstracts, 1995(6): 266A.
[18]THORNTON C,ZHANG L. Numerical Simulations of the Direct Shear Test[J]Chemical Engineering & Technology, 2003, 26(2): 153-156.