长江科学院院报 ›› 2012, Vol. 29 ›› Issue (10): 82-85.DOI: 10.3969/j.issn.1001-5485.2012.10.016

• 水力学 • 上一篇    下一篇

高水头深孔平板门门槽水力特性研究

王均星, 王瑞峰, 陈利强, 杜少磊   

  1. 武汉大学 水资源与水电科学国家重点实验室, 武汉  430072
  • 收稿日期:2011-08-14 出版日期:2012-10-01 发布日期:2012-10-18
  • 作者简介:王均星(1963-),男,湖北宜城人,教授,博士生导师,主要从事水工水力学专业的教学与科研工作

Hydraulic Properties of High-Head Deep-Hole Bulkhead Gate Slot

WANG Jun-xing, WANG Rui-feng, CHEN Li-qiang, DU Shao-lei   

  1. State Key Laboratory of Water Resources and Hydropower Engineering Science, Wuhan University, Wuhan  430072, China
  • Received:2011-08-14 Online:2012-10-01 Published:2012-10-18

摘要: 平板闸门门槽内的水流流态十分复杂,容易因空化空蚀而破坏门槽。以卡基娃水电站放空洞工程为实例,采用水工模型试验探讨门槽附近水流流态、压力、空化数的变化规律。研究结果表明:有压式门后连接段能较好地改善门槽及门后连接段水流的流态;闸门全开时,各个区域没有负压出现,水流发生空化的可能性也较低;闸门局开时,门槽及门后连接段会出现负压,最大负压出现在门槽的底板处,水流发生空化的可能性也较大;水流的脉动表现出明显振幅大、频率低的强紊流脉动压力的特点。研究成果对于高水头深孔闸门门槽的设计具有一定的借鉴意义。

关键词: 水工模型试验, 平板门, 门槽, 水力特性

Abstract: Flow regime in the bulkhead gate slot is very complex and the slot is easily damaged because of flow cavitation. We investigated the variation regularity of flow regime, pressure, and cavitation number of the segment near the gate slot through hydraulic model test. The emptying tunnel of Kajiwa Hydropower Station was taken as a case study. Results showed that pressure-flow segment behind the gate could improve the flow regime. When the gate was fully open, no negative pressure appeared in each area, and the possibility of water cavitation was rather low. When the gate was partially open, negative pressure was found in the gate slot and the segment behind the gate, with peak negative pressure on the floor of the gate slot, and high possibility of water cavitation. The water fluctuation was featured by large amplitude and low frequency, which was the characteristics of strong turbulent flow. The results could provide reference for the slot design of high-head deep-hole bulkhead gate.

Key words: hydraulic model test, bulkhead gate, gate slot, hydraulic properties

中图分类号: